Toyota 4Runner: Red Indicator Remains On

Toyota 4Runner Service Manual / Audio / Visual / Telematics / Cellular Communication / Safety Connect System / Red Indicator Remains On

DESCRIPTION

This means that the DCM (Telematics Transceiver) detects a malfunction in the Safety Connect and stores a DTC.

PROCEDURE

1.	CHECK FOR DTC

(a) Turn the ignition switch off.

(b) Connect the Techstream to the DLC3.

(d) Perform "Health Check" and check for current DTCs (See page ).

Result

Result	Proceed to
DTC is not output	A
DTC is output	B

GO TO DIAGNOSTIC TROUBLE CODE CHART

2.	REPLACE DCM (TELEMATICS TRANSCEIVER)

(a) Replace the DCM (Telematics Transceiver) (See page ).

NOTICE:

The ignition switch must be off.
Do not replace the DCM (Telematics Transceiver) with one from another vehicle.

PERFORM DCM ACTIVATION

Green Indicator Remains Off

DESCRIPTION After the ignition switch is turned to ON, the DCM (Telematics Transceiver) will enter a self check mode. The manual (SOS) switch red indicator will illuminate for 2 seconds and turn ...

Unable To Connect To Call Center

DESCRIPTION This may occur when the intensity of the telephone radio frequency was very weak, PRL updates are required or the Safety Connect system has a malfunction, and a DTC is stored. PROCED ...

Other materials about Toyota 4Runner:

Inspection
INSPECTION PROCEDURE 1. INSPECT WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY (a) Remove the washer jar. (b) Disconnect the windshield washer motor and pump connector. HINT: Make sure that the windshield washer motor and pump is installed to the washer jar ...

Lost Communication with ECM / PCM "A" (U0100)
DESCRIPTION DTC Code DTC Detection Condition Trouble Area U0100 There is no communication from the ECM. Power source or inside ECM ECM main wire or connector ECM ...