REGISTRATION
PROCEDURE
1. DESCRIPTION OF CODE REGISTRATION
HINT:
2. REGISTER RECOGNITION CODE (USING TECHSTREAM)
HINT:
For detailed procedures, refer to the prompts on the Techstream screen. The number of currently registered codes can be checked on the first screen of Wireless Code Registration.
(a) Turn the ignition switch to ON.
(b) Enter the following menus: Body Electrical / Main Body / Utility / Wireless Code Registration.
(c) Press both the lock and unlock switches at the same time for 1 to 1.5 seconds.
(d) Press either switch for more than 1 second within 3 seconds.
(e) Check the response to the registration completion.
HINT:
(f) Perform either of the following to complete the registration of the recognition codes:
3. REGISTER RECOGNITION CODE (USING SWITCH OPERATION)
(a) Make sure the following conditions are met.
(b) Insert and remove the key into/from the ignition key cylinder twice (Insert → Remove → Insert → Remove) within 5 seconds.
HINT:
The procedure should end with the key removed.
(c) Perform the following operations within 40 seconds.
(1) Close and open the driver side door twice (Close → Open → Close → Open).
HINT:
The procedure should end with the door open.
(2) Insert and remove the key into/from the ignition key cylinder (Insert → Remove).
HINT:
The procedure should end with the key removed.
(3) Close and open the driver side door twice (Close → Open → Close → Open).
HINT:
The procedure should end with the door open.
(4) Insert the key into the ignition key cylinder and close all the doors.
(d) Perform the following operations within 40 seconds.
(1) Turn the ignition switch to ON and then off at approximately 1 second intervals. Operate the ignition switch according to the number of times shown below.
HINT:
If the number of ignition switch ON - off operations is 0, 4, or 6 or more, there will be no response (power door lock and unlock operation) to show which mode has been selected.
(2) Remove the key from the ignition key cylinder.
(e) Check that the response begins within 5 seconds after completing the above step, and that the response matches the selected mode.
NOTICE:
After the system has been set to prohibition mode, enter the confirmation mode and check that the number of registered keys is 0.
HINT:
(f) If add mode or rewrite mode is selected, perform the following procedures.
(1) Press a single switch (lock or unlock) within 5 seconds.
(2) Check that the response begins within 3 seconds after completing the above step, and that the response indicates that registration has been completed correctly.
HINT:
(g) Perform either of the following to complete the registration of the recognition codes:
Front Seat Inner Belt Assembly
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL FRON ...
System Description
SYSTEM DESCRIPTION
1. DESCRIPTION
(a) Safety Connect performs ACN (Automatic Collision Notification), manual emergency
calling, stolen vehicle tracking and roadside assistance service, by audio and data
communications between the vehicle and call center ...