On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
2. REMOVE WINDSHIELD WASHER RELAY
(a) Remove the windshield washer relay from the engine room relay box. Text in Illustration
|
|
3. INSPECT WINDSHIELD WASHER RELAY
(a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the windshield washer relay. |
|
4. INSTALL WINDSHIELD WASHER RELAY
(a) Install the windshield washer relay to the engine room relay box.
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL SHIFT LOCK CONTROL ECU SUB-ASSEMBLY
(a) Attach the 3 claws to install the shift lock control ECU to the transmission
floor shift.
(b) Connect the shift lock solenoid connector to the shift lock control ECU.
2. INSTALL IND ...
Center Differential Lock Position Switch (C1282)
DESCRIPTION
DTC C1282 is stored only in test mode.
DTC Code
DTC Detection Condition
Trouble Area
C1282
Stored during test mode.
Harness or connector
Transfer system
...