Toyota 4Runner: Relay

Toyota 4Runner Service Manual / Vehicle Interior / Lighting (int) / Relay

On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT DOME RELAY

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
3 - 5	Voltage is not applied between terminals 1 and 2	10 kΩ or higher
3 - 5	Voltage is applied between terminals 1 and 2	Below 1 Ω

If the result is not as specified, replace the DOME relay.

Rear Door Courtesy Switch

Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY (a) Measure the resistance according to the value(s) in t ...

Room Light(for Front)

Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT MAP LIGHT ASSEMBLY (a) Measure the resistance according to the value(s) in the table below. Sta ...

Other materials about Toyota 4Runner:

Removal
REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system. NOTICE: When disconnecting the cable, some systems ne ...

System Description
SYSTEM DESCRIPTION 1. FRONT POWER SEAT CONTROL SYSTEM DESCRIPTION The driver seat is equipped with slide, reclining, lifter, front vertical and lumbar support adjustment functions. The passenger seat is equipped with slide and reclining adjust ...