On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. REMOVE DEICER RELAY (DEICER)
(a) Remove the deicer relay from the engine room relay block. Text in Illustration
|
|
2. INSPECT DEICER RELAY
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
3 - 5 |
Battery voltage is not applied to terminals 1 and 2 |
10 kΩ or higher |
3 - 5 |
Battery voltage is applied to terminals 1 and 2 |
Below 1 Ω |
If the result is not as specified, replace the deicer relay.
3. INSTALL DEICER RELAY
(a) Install the deicer relay to the engine room relay block.
Using the interior lights
Interior lights list
1. Rear interior light
2. Front interior light/front personal lights
3. Shift lever light (when the engine switch is in the “ACC” or “ON” position
[without a smart key system] or “ENGINE START STOP” switch is in ACCESS ...
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple
suspected areas are listed, the potential causes of the symptoms are listed in order
of probability in the "Suspected Area" column of ...