On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. REMOVE PTC HEATER RELAY (PTC NO. 1, PTC NO. 1, PTC NO. 3)
(a) Remove the 3 PTC heater relays from the engine room relay block. Text in Illustration
|
|
2. INSPECT PTC HEATER RELAY (PTC NO. 1, PTC NO. 2, PTC NO. 3)
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
3 - 5 |
Battery voltage not applied between terminals 1 and 2 |
10 kΩ or higher |
Battery voltage applied to terminal 1 and 2 |
Below 1 Ω |
3. INSTALL PTC HEATER RELAY (PTC NO. 1, PTC NO. 2, PTC NO. 3)
(a) Install the 3 PTC heater relays to the engine room relay block.
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are listed in order of probability in the "Suspected Area" ...
Reassembly
REASSEMBLY
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. TEMPORARILY INSTALL FRONT DISC BRAKE BLEEDER PLUG
(a) Temporarily install the front dis ...