REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
2. REMOVE DOOR SCUFF PLATE ASSEMBLY RH
3. REMOVE COWL SIDE TRIM BOARD RH
4. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
5. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
6. REMOVE INSTRUMENT LOWER COVER LH
7. REMOVE INSTRUMENT NO. 2 LOWER PANEL AIRBAG ASSEMBLY
8. REMOVE INSTRUMENT PANEL BOX DOOR COVER
9. REMOVE INSTRUMENT LOWER PANEL SUB-ASSEMBLY
10. REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY
11. REMOVE ECU INTEGRATION BOX RH
12. REMOVE POWER STEERING ECU ASSEMBLY
(a) Using a screwdriver, detach the 2 claws and remove the power steering ECU assembly. HINT: Tape the screwdriver tip before use. |
|
Back Door Power Window Switch ON Stuck (B2312)
DESCRIPTION
This DTC is stored when the back door power window regulator motor is stuck.
NOTICE:
When a power window regulator is reinstalled or replaced, the power window control
system must be initialized.
Back Door P/W
DTC Code
...
Terminals Of Ecu
TERMINALS OF ECU
1. CHECK 4WD CONTROL ECU
(a) Measure the voltage and resistance according to the value(s) in the table
below.
Terminal No. (Symbol)
Wiring Color
Terminal Description
Condition
Speci ...