REMOVAL
CAUTION / NOTICE / HINT
NOTICE:
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
2. REMOVE FRONT WHEEL RH
3. REMOVE FRONT FENDER APRON SEAL RH
4. REMOVE V-BANK COVER SUB-ASSEMBLY
5. REMOVE AIR CLEANER CAP AND HOSE
6. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
7. REMOVE AIR CLEANER CASE
8. REMOVE FAN AND GENERATOR V BELT
9. DISCONNECT POWER STEERING OIL PRESSURE SWITCH CONNECTOR
(a) Disconnect the 2 connectors. |
|
10. DISCONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE
(a) Slide the clip and disconnect the oil reservoir to pump hose from the vane pump. |
|
11. DISCONNECT NO. 1 PRESSURE FEED TUBE
(a) Remove the union bolt and disconnect the pressure feed tube. |
|
(b) Remove the gasket.
12. REMOVE VANE PUMP ASSEMBLY
(a) Remove the bolt and harness bracket. |
|
(b) Remove the 2 bolts and vane pump. |
|
Only Back Door cannot be Opened
DESCRIPTION
When the back door is unlock and the multiplex network door ECU (back door P/W)
receives the ON signal from the back door opener switch, it sends the signal to
the main body ECU (multiplex network body ECU) which then activates the back door
...
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK DTC (CHECK USING TECHSTREAM)
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Navigation System / Trouble
Codes.
(e) Chec ...