REMOVAL
CAUTION / NOTICE / HINT
NOTICE:
Be sure to read the precaution before performing this procedure (See page ).
HINT:
PROCEDURE
1. REMOVE FRONT WHEEL
2. REMOVE LOWER FRONT BUMPER COVER
3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
4. REMOVE FRONT SUSPENSION MEMBER BRACE SUB-ASSEMBLY
5. REMOVE FRONT STABILIZER END BRACKET (w/ KDSS)
6. REMOVE FRONT STABILIZER BAR (w/ KDSS)
7. DISCONNECT FRONT STABILIZER LINK ASSEMBLY LH (w/o KDSS)
(a) Remove the nut and disconnect the stabilizer link from the steering knuckle. HINT: If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud. |
|
8. DISCONNECT FRONT STABILIZER LINK ASSEMBLY RH (w/o KDSS)
HINT:
Use the same procedure described for the LH side.
9. REMOVE FRONT NO. 1 STABILIZER BRACKET LH (w/o KDSS)
10. REMOVE FRONT NO. 1 STABILIZER BRACKET RH (w/o KDSS)
11. REMOVE FRONT STABILIZER BAR (w/o KDSS)
12. REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING (w/ REAS)
NOTICE:
Perform this procedure with the vehicle jacked up so that all the shock absorbers are extended.
(a) As shown in the illustration, loosen the nut and disconnect the tube. Text in Illustration
NOTICE: Never loosen the absorber hoses or the flare nuts at the joint parts. |
|
(b) Remove the bolt and bracket. |
|
(c) Remove the bolt, nut and washer. |
|
(d) Remove the 3 nuts on the top of the front shock absorber with coil spring. |
|
13. REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING (w/o REAS)
(a) Remove the bolt, nut and washer. |
|
(b) Remove the 3 nuts on the top of the front shock absorber with coil spring. |
|
(c) Remove the front shock absorber with coil spring.
Drive Shaft System
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of the problem symptom. The potential
causes of the symptoms are listed in order of probability in the "Suspected Area"
column of the table. ...
Rear Wiper does not Operate
DESCRIPTION
The windshield wiper switch controls the rear wiper motor.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
HINT:
Since the wiper and washer system has functions that use LIN communication, first
confirm that there is no malfunction in the communica ...