REMOVAL
PROCEDURE
1. REMOVE FRONT WHEEL
2. REMOVE SIDE STEP ASSEMBLY LH
3. REMOVE STABILIZER CONTROL VALVE PROTECTOR
4. DRAIN SUSPENSION FLUID
5. REMOVE LOWER FRONT BUMPER COVER
6. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
7. REMOVE FRONT SUSPENSION MEMBER BRACE SUB-ASSEMBLY
(a) Remove the 6 bolts and 2 member braces from the front frame assembly. |
|
8. REMOVE FRONT STABILIZER END BRACKET
(a) Remove the 4 bolts and 2 brackets from the lower arm. |
|
9. REMOVE FRONT STABILIZER BAR
(a) Remove the 4 bolts, 2 front stabilizer lower brackets and front stabilizer bar. |
|
(b) Remove the 2 front stabilizer link bushes and front stabilizer lower bracket bushes from the front stabilizer bar.
10. REMOVE FRONT FENDER APRON SEAL LH
(a) Remove the 7 clips and front apron seal LH. |
|
11. REMOVE FRAME APRON SEAL BRACKET
(a) Remove the bolt and bracket. |
|
12. DISCONNECT NO. 1 FRONT STABILIZER CONTROL TUBE ASSEMBLY
(a) Using a union nut wrench, disconnect the 2 front stabilizer control tubes. |
|
(b) Remove the bolt.
13. REMOVE FRONT STABILIZER WITH TUBE CYLINDER ASSEMBLY
(a) Remove the bolt, nut and front stabilizer with tube cylinder assembly.
NOTICE:
(b) Remove the 2 bleeder plug caps and bleeder plugs from the front stabilizer with tube cylinder assembly.
14. REMOVE FRONT STABILIZER LINK ASSEMBLY RH
(a) Remove the bolt and front stabilizer link assembly. |
|
Rear window and outside rear view mirror defoggers
Defoggers are used to defog the rear window, and to remove raindrops, dew
and frost from the outside rear view mirrors.
Before operating the defoggers, make sure the back window is completely
closed.
Vehicles with a manual air conditioning system
Tu ...
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
When installing the window frame moulding, heat the vehicle body and
window frame moulding using a ...