REMOVAL
PROCEDURE
1. REMOVE SIDE STEP ASSEMBLY LH
2. REMOVE STABILIZER CONTROL VALVE PROTECTOR
3. DRAIN SUSPENSION FLUID
4. REMOVE REAR STABILIZER LOWER BRACKET
(a) Remove the 4 bolts and 2 rear stabilizer lower brackets. |
|
5. REMOVE REAR STABILIZER BAR SUB-ASSEMBLY
(a) Remove the 2 bolts, 2 nuts and rear stabilizer bar. NOTICE: Turn the bolts while holding the nuts. |
|
(b) Remove the 2 stabilizer bushes from the rear stabilizer bar.
6. DISCONNECT REAR STABILIZER CONTROL TUBE ASSEMBLY
(a) Remove the 2 union bolts and 2 pressure port gaskets and disconnect the rear stabilizer control tube from the rear stabilizer control cylinder. |
|
7. REMOVE REAR STABILIZER CONTROL CYLINDER
(a) Remove the bolt, nut and rear stabilizer control cylinder. NOTICE: Do not hold the rear stabilizer control cylinder by the cylinder boot. HINT: Turn the nut while holding the bolt. |
|
(b) Remove the 2 bleeder plug caps from the rear stabilizer control cylinder.
8. REMOVE REAR STABILIZER LINK ASSEMBLY
(a) Remove the bolt, nut and rear stabilizer link assembly. HINT: Turn the nut while holding the bolt. |
|
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL FRONT DIFFERENTIAL SIDE GEAR SHAFT BEARING RH
(a) Using SST and a press, press in the shaft bearing.
SST: 09223-00010
(b) Using a snap ring expander, install the snap ring.
HINT:
Install the snap ring securely.
2. INST ...
Initialization
INITIALIZATION
1. INITIALIZE AUTOMATIC RUNNING BOARD SYSTEM
NOTICE:
When a side auto step controller ECU assembly is replaced, the side auto step
controller ECU assembly must be initialized. Functions such as deploying/stowing
and jam protection do not ...