REMOVAL
PROCEDURE
1. REMOVE FRONT BUMPER COVER (w/o Intuitive Parking Assist System)
(See Page )
2. REMOVE FRONT BUMPER COVER (w/ Intuitive Parking Assist System)
(See Page )
3. REMOVE HIGH PITCHED HORN ASSEMBLY
4. REMOVE RADIATOR GRILLE BRACKET
5. REMOVE LOW PITCHED HORN ASSEMBLY
6. REMOVE HOOD LOCK CONTROL CABLE COVER
(a) Remove the 2 bolts. |
|
(b) Detach the claw to remove the hood lock control cable cover.
7. REMOVE HOOD LOCK ASSEMBLY
(a) Remove the 3 bolts. |
|
(b) Detach the clamp. |
|
(c) w/ Engine Hood Courtesy Switch:
Disconnect the connector.
(d) w/o Engine Hood Courtesy Switch:
Disconnect the connector cap.
(e) Disconnect the hood lock control cable and remove the hood lock assembly.
8. REMOVE DOOR SCUFF PLATE ASSEMBLY LH
9. REMOVE COWL SIDE TRIM BOARD LH
10. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
(a) Detach the clamp. |
|
(b) Detach the 3 claws. |
|
(c) Disconnect the hood lock control cable assembly and remove the hood lock control lever sub-assembly.
11. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY
(a) Using a screwdriver, disconnect the 3 clamps as shown in the illustration.
Text in Illustration
*1 |
Hood Lock Control Cable Assembly |
*2 |
Stopper |
*3 |
Wire Harness |
*4 |
Grommet |
*a |
Engine Room Side |
- |
- |
HINT:
Tape the screwdriver tip before use.
(b) Pull the hood lock control cable assembly from the engine compartment to remove it.
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use the following procedures to troubleshoot the key reminder warning
system.
*: Use the Techstream.
PROCEDURE
1.
VEHICLE BROUGHT TO WORKSHOP
NEXT
...
Drive Shaft System
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of the problem symptom. The potential
causes of the symptoms are listed in order of probability in the "Suspected Area"
column of the table. ...