REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system (See page ).
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
2. REMOVE DOOR SCUFF PLATE ASSEMBLY LH
3. REMOVE COWL SIDE TRIM BOARD LH
4. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
5. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
6. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
7. REMOVE DRIVER SIDE JUNCTION BLOCK ASSEMBLY
8. REMOVE SIDE AUTO STEP CONTROLLER ECU ASSEMBLY
(a) Disconnect the 2 connectors. |
|
(b) Remove the 2 bolts.
(c) Disengage the guide and remove the side auto step controller ECU assembly.
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL SIDE AIRBAG SENSOR ASSEMBLY LH
(a) Turn the ignition switch off.
(b) Disconn ...
Lost Communication with "Seat Control Module A" (U0208)
DESCRIPTION
DTC Code
DTC Detection Condition
Trouble Area
U0208
There is no communication from the front power seat switch LH.
Power source or inside front power seat switch LH ...