REMOVAL
CAUTION / NOTICE / HINT
HINT:
Standard:
Item |
Temperature |
---|---|
Vehicle Body |
40 to 60°C (104 to 140°F) |
Window Frame Moulding |
20 to 30°C (68 to 86°F) |
Black Out Tape |
20 to 30°C (68 to 86°F) |
Outside Stripe |
20 to 30°C (68 to 86°F) |
NOTICE:
Do not heat the vehicle body, window frame moulding, black out tape or outside stripe excessively.
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH
3. REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH
4. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
5. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH
6. REMOVE FRONT DOOR SERVICE HOLE COVER LH
7. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH
8. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH
9. REMOVE FRONT DOOR GLASS RUN LH
10. REMOVE FRONT DOOR BELT MOULDING LH
11. REMOVE FRONT DOOR WEATHERSTRIP LH
12. REMOVE FRONT DOOR REAR WINDOW FRAME MOULDING LH
13. REMOVE NO. 1 BLACK OUT TAPE LH
(a) Pull back an edge of the black out tape and pull it parallel to the vehicle body to remove it.
14. REMOVE FRONT DOOR OUTSIDE STRIPE LH
(a) Pull back an edge of the front door outside stripe and pull it parallel to the vehicle body to remove it.
15. REMOVE FRONT DOOR LOWER OUTSIDE STRIPE LH
(a) Pull back an edge of the lower front door outside stripe and pull it parallel to the vehicle body to remove it.
Lost Communication with Door Side Airbag Sensor RH (B1692/81,B1697/82)
DESCRIPTION
The circuit for the side collision sensor LH or RH (to determine deployment of
the front seat side airbag LH or RH and curtain shield airbag LH or RH) is composed
of the center airbag sensor, rear airbag sensor LH or RH and side airbag sensor ...
Light Control Rheostat
Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT LIGHT CONTROL RHEOSTAT (w/o TAIL Cancel Switch)
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Conn ...