REMOVAL
CAUTION / NOTICE / HINT
HINT:
Standard:
Item |
Temperature |
---|---|
Vehicle Body |
40 to 60°C (104 to 140°F) |
Window Frame Moulding |
20 to 30°C (68 to 86°F) |
NOTICE:
Do not heat the vehicle body or window frame moulding excessively.
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH
3. REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH
4. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
5. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH
6. REMOVE FRONT DOOR SERVICE HOLE COVER LH
7. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH
8. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH
9. REMOVE FRONT DOOR GLASS RUN LH
10. REMOVE FRONT DOOR BELT MOULDING LH
11. REMOVE FRONT DOOR WEATHERSTRIP LH
(a) Detach the 3 clips and remove the upper part of the front door weatherstrip so that the moulding can be removed.
12. REMOVE FRONT DOOR REAR WINDOW FRAME MOULDING LH
(a) Remove the door window frame moulding clip. |
|
(b) Put protective tape around the front door rear window frame moulding. Text in Illustration
|
|
(c) Using a moulding remover, detach the clip and remove the double-sided tape to remove the front door rear window frame moulding.
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
A bolt without a torque specification is shown in the standard bolt chart (See
page ).
PROCEDURE
1. INSTALL MULTIPLEX NETWORK BODY ECU
NOTICE:
Make sure that no foreign objects contact the connecting ...
Removal
REMOVAL
CAUTION / NOTICE / HINT
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
PROCEDURE
1. REMOVE REAR SEAT ASSEMBLY LH
(a) Remove the rear seat assembly LH (See page
).
2. REMOVE REAR SEAT UPPER RECLINING COVER LH
...