REMOVAL
PROCEDURE
1. REMOVE JACK BOX HOLE COVER
2. REMOVE REAR QUARTER PANEL MUDGUARD LH
3. REMOVE REAR QUARTER PANEL MUDGUARD RH
HINT:
Use the same procedure as for the LH side.
4. REMOVE REAR BUMPER COVER
(a) Remove the 2 bolts and 2 screws.
(b) Put protective tape around the rear bumper cover.
(c) Remove the 2 screws and 6 bolts.
(d) Detach the 18 claws to remove the rear bumper cover.
Text in Illustration
*1 |
Protective Tape |
- |
- |
(e) Disconnect the connector.
5. REMOVE REAR BUMPER ENERGY ABSORBER
6. REMOVE REAR BUMPER BAR REINFORCEMENT LH
(a) Remove the 2 bolts and rear bumper bar reinforcement LH. |
|
7. REMOVE REAR BUMPER BAR REINFORCEMENT RH
HINT:
Use the same procedure as for the LH side.
8. REMOVE REAR BUMPER SIDE SUPPORT LH
9. REMOVE REAR BUMPER SIDE SUPPORT RH
HINT:
Use the same procedure as for the LH side.
10. REMOVE REAR COMBINATION LIGHT LENS AND BODY LH
11. REMOVE REAR COMBINATION LIGHT LENS AND BODY RH
HINT:
Use the same procedure as for the LH side.
12. REMOVE REAR BUMPER UPPER RETAINER LH
13. REMOVE REAR BUMPER UPPER RETAINER RH
HINT:
Use the same procedure as for the LH side.
14. REMOVE PINTLE HOOK SUPPORT TUBE SUB-ASSEMBLY (w/ Pintle Hook)
Precaution
PRECAUTION
1. IGNITION SWITCH EXPRESSION
HINT:
The type of ignition switch used on this model differs according to the specifications
of the vehicle. The expressions listed in the table below are used in this section.
Expression
Ign ...
Data List / Active Test
DATA LIST / ACTIVE TEST
1. READ DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches,
sensors, actuators and other items to be read without removing any parts. This non-intrusive
inspection can be very usefu ...