REMOVAL
PROCEDURE
1. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY
(a) Remove the instrument panel sub-assembly (See page ).
2. REMOVE NO. 1 HEATER TO REGISTER DUCT
3. REMOVE NO. 2 HEATER TO REGISTER DUCT
4. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT
5. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT
6. REMOVE NO. 3 HEATER TO REGISTER DUCT
7. REMOVE AUTOMATIC LIGHT CONTROL SENSOR
(a) Disconnect the connector. |
|
(b) Detach the 2 claws and remove the sensor.
Test Mode Procedure
TEST MODE PROCEDURE
NOTICE:
After replacing the master cylinder solenoid and/or yaw rate and acceleration
sensor, perform calibration.
VSC is prohibited during test mode.
HINT:
By switching the skid control ECU from normal mod ...
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK FOR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Air Conditioner / Trouble Codes.
(e) Check for DTCs.
2. CLEAR DTC ...