REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
2. REMOVE ROOF HEADLINING ASSEMBLY
(a) Remove the roof headlining assembly (See page ).
3. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH
(a) Remove the curtain shield airbag assembly LH (See page ).
4. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY RH
HINT:
Use the same procedures described for the LH side.
5. REMOVE SLIDING ROOF SIDE GARNISH LH
(a) Detach the 5 claws and remove the side garnish.
6. REMOVE SLIDING ROOF SIDE GARNISH RH
HINT:
Use the same procedures described for the LH side.
7. REMOVE SLIDING ROOF GLASS SUB-ASSEMBLY
(a) Using a T25 "TORX" driver, remove the 4 screws and glass.
8. REMOVE SLIDING ROOF WEATHERSTRIP
(a) Remove the sliding roof weatherstrip.
9. REMOVE SLIDING ROOF HOUSING SUB-ASSEMBLY
(a) Disconnect the 4 sliding roof drain hoses.
(b) Remove the 8 bolts and 4 nuts.
(c) Loosen the 4 nuts as shown in the illustration.
NOTICE:
Be sure that the nuts are fully threaded onto the bolts.
(d) Pull the sliding roof housing sub-assembly downward and detach the 2 claws of the sliding roof lock catch plate LH from the stud bolt as shown in the illustration. Text in Illustration
NOTICE: Performing this procedure breaks the claws of the sliding roof lock catch plate LH so that the sliding roof housing sub-assembly can be removed. However, do not use excessive force. |
|
(e) Remove the 4 nuts and sliding roof housing sub-assembly.
(f) Detach the 2 claws and remove the sliding roof lock catch plate LH from the sliding roof housing sub-assembly. HINT: The sliding roof lock catch plate LH is used when the vehicle is assembled at the factory and is not needed for reinstallation. |
|
Multi-terrain Select Indicator Light does not Come ON
DESCRIPTION
When the ON/OFF switch of the multi-terrain select switch is turned on, multi-terrain
select control is enabled and the multi-terrain select indicator light illuminates.
After selecting a road surface type using the mode selector switch of the ...
Wheels
If a wheel is bent, cracked or heavily corroded, it should be replaced.
Otherwise, the tire may separate from the wheel or cause a loss of handling
control.
Wheel selection
When replacing wheels, care should be taken to ensure that they are
equivalent ...