Toyota 4Runner: Removal

Toyota 4Runner Service Manual / Vehicle Exterior / Window / Glass / Power Window Regulator Motor(for Rear Door) / Removal

REMOVAL

PROCEDURE

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

2. REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH

3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

4. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH

5. REMOVE REAR SPEAKER ASSEMBLY

6. REMOVE REAR DOOR SERVICE HOLE COVER LH

7. REMOVE REAR DOOR GLASS RUN LH

8. REMOVE REAR DOOR WINDOW REAR LOWER FRAME SUB-ASSEMBLY LH

9. REMOVE REAR DOOR QUARTER WINDOW GLASS LH

10. REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH

11. REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

12. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

(a) Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor.

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ...

Inspection

INSPECTION PROCEDURE 1. INSPECT REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (a) Check that the motor gear rotates smoothly as follows. NOTICE: Do not apply positive (+) battery v ...

Other materials about Toyota 4Runner:

Propeller Shaft System
Problem Symptoms Table PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. ...

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. CHECK TURN SIGNAL FLASHER ASSEMBLY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition ...