REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
2. REMOVE FRONT BUMPER COVER (w/o Intuitive Parking Assist System)
(See page )
3. REMOVE FRONT BUMPER COVER (w/ Intuitive Parking Assist System)
(See page )
4. REMOVE FRONT FENDER LINER RH
(See page )
5. DRAIN WINDSHIELD WASHER FLUID
(a) Disconnect the washer hose from the hose of the windshield washer motor and pump assembly and drain the windshield washer fluid. |
|
6. REMOVE WASHER INLET SUB-ASSEMBLY
(a) Detach the clip and remove the washer inlet sub-assembly. |
|
7. REMOVE WASHER JAR
(a) Disconnect the connector. |
|
(b) Remove the 3 screws. |
|
(c) Detach the guide to remove the washer jar. |
|
8. REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY
(a) Remove the windshield washer motor and pump assembly from the packing of the washer jar. Text in Illustration
|
|
Communication Malfunction No. 1 (B2797)
DESCRIPTION
This DTC is stored when a communication error occurs between the transponder
key amplifier and transponder key ECU assembly. Some possible reasons for the communication
error are: 1) 2 or more ignition keys are positioned too close together, o ...
Registration
REGISTRATION
PROCEDURE
1. DESCRIPTION OF CODE REGISTRATION
HINT:
Recognition code registration is necessary when replacing door control
transmitter or door control receiver.
Add mode is used to register new recognition codes while still ret ...