Toyota 4Runner: Removal

Toyota 4Runner Service Manual / Vehicle Interior / Door Lock / Door Control Switch / Removal

REMOVAL

PROCEDURE

1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH RH

(a) Detach the 2 clips and remove the front door lower frame bracket garnish RH.

2. REMOVE DOOR NO. 2 INSIDE HANDLE BEZEL RH

(a) Using a moulding remover, detach the 3 claws and remove the No.2 inside handle bezel RH as shown in the illustration.

3. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY RH

(a) Detach the 4 claws and 2 door armrest caps.

(b) Remove the 3 screws.

(d) Pull out the front door trim board sub-assembly RH in the direction indicated by the arrow as shown in the illustration.

Text in Illustration

*1	Reference Boss

(e) Raise the front door trim board sub-assembly RH to detach the 4 claws and remove the front door trim board sub-assembly RH together with the front door inner glass weatherstrip RH.

(f) Disconnect the connector.

(g) Disconnect the front door lock remote control cable assembly and front door inside locking cable assembly.

4. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP RH

(a) Using a screwdriver, detach the 4 claws and remove the front door inner glass weatherstrip RH from the front door trim board sub-assembly RH as shown in the illustration.

5. REMOVE DOOR CONTROL SWITCH ASSEMBLY

(a) Disconnect the door control switch connector.

(b) Detach the 2 claws and remove the door control switch assembly.

Inspection

INSPECTION PROCEDURE 1. INSPECT DOOR CONTROL SWITCH ASSEMBLY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester ...

Installation

INSTALLATION PROCEDURE 1. INSTALL DOOR CONTROL SWITCH ASSEMBLY (a) Attach the 2 claws to install the door control switch assembly. (b) Con ...

Other materials about Toyota 4Runner:

Lost Communication with Front Airbag Sensor RH (B1612/83,B1613/83)
DESCRIPTION The front airbag sensor RH circuit consists of the center airbag sensor and front airbag sensor RH. The front airbag sensor RH detects impacts to the vehicle and sends signals to the center airbag sensor to determine if the airbag should be d ...

Sound Quality is Bad Only when Disc is Played (Volume is Too Low)
CAUTION / NOTICE / HINT NOTICE: After replacing the navigation receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary. PROCEDURE 1. REPLACE DISC AND RECHECK ...