REMOVAL
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH
3. REMOVE DOOR NO. 2 INSIDE HANDLE BEZEL LH
4. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
5. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH
6. REMOVE FRONT DOOR SERVICE HOLE COVER LH
7. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH
8. REMOVE FRONT DOOR GLASS RUN LH
9. REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH
10. REMOVE FRONT DOOR OUTSIDE HANDLE COVER LH
11. REMOVE FRONT DOOR LOCK ASSEMBLY LH
(a) Disconnect the connector.
(b) Using a T30 "TORX" wrench, remove the 3 screws. |
|
(c) Slide the front door lock assembly downward, pull out the front door lock open rod from the outside handle frame, and remove the front door lock assembly and cables as a unit.
(d) Remove the front door lock open rod from the front door lock assembly.
(e) Remove the door lock wiring harness seal from the front door lock assembly.
12. REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH
13. REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH
Transmission Range Sensor Circuit Malfunction (PRNDL Input) (P0705)
DESCRIPTION
The Park/Neutral Position (PNP) switch detects the shift lever position and sends
signals to the ECM.
DTC Code
DTC Detection Condition
Trouble Area
P0705
One of the following conditio ...
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK FOR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Air Conditioner / Trouble Codes.
(e) Check for DTCs.
2. CLEAR DTC ...