REMOVAL
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
2. REMOVE REAR DOOR INSIDE HANDLE BEZEL LH
3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
4. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH
5. REMOVE REAR DOOR SERVICE HOLE COVER LH
6. REMOVE REAR DOOR GLASS RUN LH
7. REMOVE REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY LH
8. REMOVE REAR DOOR QUARTER WINDOW GLASS LH
9. REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH
10. REMOVE REAR DOOR LOCK ASSEMBLY LH
(a) Using a T30 "TORX" wrench, remove the 3 screws. |
|
(b) Move the rear door lock assembly downward, pull the release plate out of the rear door outside handle frame, and remove the rear door lock assembly and cables as a unit.
(c) Remove the door lock wiring harness seal from the rear door lock assembly.
11. REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH
12. REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH
Adjusting the position of and opening and closing the air outlets
Front center outlets
1. Direct air flow to the left or right, up or down.
2. Turn the knob to open or close the vent.
Front side outlets
1. Direct air flow to the left or right, up or down.
2. Turn the knob to open or close the vent.
Rear outlets
...
Lost Communication with Gateway Module (U1002)
DESCRIPTION
The main body ECU (multiplex network body ECU) stores this DTC when
no signals can be received from the ECUs that are memorized as those connected
to the CAN MS bus.
When the main body ECU (multiplex network body ECU) receives a ...