REMOVAL
CAUTION / NOTICE / HINT
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
PROCEDURE
1. REMOVE REAR SEAT HEADREST ASSEMBLY
(a) Remove the headrest.
2. REMOVE REAR SEAT TRACK INNER BRACKET COVER
(a) Using a moulding remover, detach the 2 claws and guide, and then remove the cover.
3. REMOVE REAR SEAT TRACK OUTER BRACKET COVER
(a) Using a moulding remover, detach the 2 claws.
(b) Move the cover in the direction of the arrow to detach the 2 guides and remove the cover.
4. REMOVE SEAT TRACK INNER BRACKET COVER RH
(a) Using a clip remover, detach the 8 clips and remove the cover.
5. REMOVE REAR SEAT TRACK COVER RH
(a) Using a clip remover, detach the 5 clips and claw, and then remove the cover.
6. REMOVE REAR SEAT ASSEMBLY RH
(a) Disconnect the center inner seat belt from the seat.
(b) Remove the 5 bolts and nut.
(c) Remove the rear seat.
NOTICE:
Be careful not to damage the vehicle body.
HINT:
Be sure to remove the seat with the seatback folded down.
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are listed in order of probability in the "Suspected Area" ...
Reverse Signal Circuit
DESCRIPTION
The navigation receiver assembly receives a reverse signal from the park/neutral
position switch assembly.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
After replacing the navigation receiver assembly of vehicles subscribed
t ...