REMOVAL
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. REMOVE REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat)
2. REMOVE QUARTER SCUFF PLATE LH (w/ Rear No. 2 Seat)
3. REMOVE REAR DOOR SCUFF PLATE LH
4. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH
5. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM COVER (w/ Deck Board)
6. REMOVE NO. 1 DECK BOARD SUB-ASSEMBLY (w/o Deck Board)
7. REMOVE NO. 2 LUGGAGE COMPARTMENT TRIM COVER (w/ Deck Board, w/o Rear No. 2 Seat)
8. REMOVE NO. 2 DECK BOARD SUB-ASSEMBLY (w/ Deck Board)
9. REMOVE REAR NO. 2 FLOOR BOARD ASSEMBLY (w/ Deck Board)
10. REMOVE LUGGAGE COMPARTMENT SIDE COVER SUB-ASSEMBLY LH (w/ Deck Board)
11. REMOVE LUGGAGE COMPARTMENT SIDE COVER SUB-ASSEMBLY RH (w/ Deck Board)
12. REMOVE DECK BOARD ASSEMBLY (w/ Deck Board)
13. REMOVE INNER FLOOR SIDE RAIL SUB-ASSEMBLY (w/ Deck Board)
14. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE
15. REMOVE REAR FLOOR CARPET ASSEMBLY (w/o Deck Board)
16. REMOVE REAR NO. 1 SEAT OUTER LAP BELT ANCHOR COVER
17. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
18. REMOVE FRONT DECK SIDE TRIM COVER LH
19. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM COVER
20. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
(a) w/o Rear No. 2 Seat:
(1) Remove the bolt and disconnect the rear No. 1 seat outer belt floor anchor.
(2) Remove the 3 bolts and 2 screws.
(3) Detach the 7 clips, 5 claws and 2 guides and remove the deck trim side panel.
(4) Detach the 4 claws and 2 guides, pass the rear seatback lock control lever base through the deck trim side panel, and remove the deck trim side panel. |
|
(b) w/ Rear No. 2 Seat:
(1) Remove the bolt and disconnect the rear No. 1 seat outer belt floor anchor. |
|
(2) Remove the bolt and disconnect the rear No. 2 seat outer belt floor anchor. |
|
(3) for RH Side: Remove the bolt and disconnect the rear No. 2 seat outer belt floor anchor. |
|
(4) Remove the 3 bolts and 2 screws.
(5) Detach the 7 clips, 5 claws and 2 guides.
21. REMOVE REAR NO. 2 WINDOW SIDE GARNISH ASSEMBLY LH
22. REMOVE REAR WINDOW SIDE GARNISH ASSEMBLY LH
23. REMOVE REAR NO. 2 SEATBACK LOCK STRIKER SUB-ASSEMBLY LH (w/o Rear No. 2 Seat)
24. REMOVE REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH
(a) Remove the bolt and rear No. 1 seat outer belt shoulder anchor. |
|
(b) Remove the 2 bolts and rear No. 1 seat outer belt assembly. |
|
Short in Telephone Antenna Circuit (B1573,B15CB)
DESCRIPTION
This DTC is stored when the DCM (Telematics Transceiver) detects an open or a
short in the telephone and GPS antenna circuit. The DCM (Telematics Transceiver)
sends and receives signals at a radio frequency of between 824 and 894 MHz or 1850
...
Terminals Of Ecu
TERMINALS OF ECU
1. CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY, MAIN BODY ECU (MULTIPLEX NETWORK
BODY ECU)
(a) Remove the main body ECU (See page ).
(b) Measure the voltage and resistance according to the value(s) in the table
below.
Termi ...