REMOVAL
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. REMOVE REAR NO. 2 SEAT ASSEMBLY
(a) Remove the rear No. 2 seat assembly (See page ).
2. REMOVE REAR NO. 1 FLOOR STEP COVER
3. REMOVE QUARTER SCUFF PLATE LH
4. REMOVE REAR DOOR SCUFF PLATE LH
5. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH
6. REMOVE REAR NO. 1 SEAT OUTER LAP BELT ANCHOR COVER
7. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
8. REMOVE FRONT DECK SIDE TRIM COVER LH
9. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
(a) Remove the bolt and disconnect the rear No. 1 seat outer belt floor anchor. |
|
(b) Remove the bolt and disconnect the rear No. 2 seat outer belt floor anchor. |
|
(c) for RH Side: Remove the bolt and disconnect the rear No. 2 seat outer belt floor anchor. |
|
(d) Remove the 3 bolts and 2 screws.
(e) Detach the 7 clips, 5 claws and 2 guides and remove the deck trim side panel.
10. REMOVE REAR NO. 2 WINDOW SIDE GARNISH ASSEMBLY LH
11. REMOVE REAR WINDOW SIDE GARNISH ASSEMBLY LH
12. REMOVE REAR NO. 2 SEAT OUTER BELT ASSEMBLY LH
(a) Remove the bolt and rear No. 2 seat outer belt shoulder anchor. |
|
(b) Remove the 2 bolts and rear No. 2 seat outer belt assembly. |
|
13. REMOVE REAR SEAT OUTER BELT ANCHOR PLATE SUB-ASSEMBLY LH
(a) Remove the bolt and anchor plate. |
|
14. REMOVE SEAT BELT ANCHOR PLATE ASSEMBLY
(a) Remove the 2 bolts and anchor plate. |
|
Dtc Check / Clear
DTC CHECK / CLEAR
CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Navigation System / Trouble
Codes.
(e) Check for DTCs (Click here ).
...
Unable to Lock Steering Wheel
DESCRIPTION
The steering lock ECU sends an unlock position signal to the power management
control ECU. Upon receiving the signal, the power management control ECU permits
an engine start. This prevents the engine from being started with the steering locke ...