REMOVAL
PROCEDURE
1. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY
(a) Remove the instrument panel sub-assembly (See page ).
2. REMOVE NO. 2 INSTRUMENT PANEL WIRE
(a) Detach the clamp. |
|
(b) Disconnect the 2 connectors and remove the wire.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.
3. REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
(a) Remove the 2 screws. |
|
(b) Detach the 5 hooks (A). Text in Illustration
|
|
(c) Detach the 5 hooks (B) and remove the instrument panel passenger airbag.
Installation
INSTALLATION
CAUTION / NOTICE / HINT
PROCEDURE
1. TEMPORARILY INSTALL BRAKE MASTER CYLINDER PUSH ROD CLEVIS
(a) Install the lock nut and brake master cylinder push rod clevis to the brake
booster assembly.
HINT:
Tighten the lock nut after adjusting the ...
Installation
INSTALLATION
CAUTION / NOTICE / HINT
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. INS ...