REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
2. REMOVE DOOR SCUFF PLATE ASSEMBLY RH
HINT:
Use the same procedure as for the LH side (See page ).
3. REMOVE COWL SIDE TRIM BOARD RH
4. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
5. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
6. REMOVE FRONT NO. 2 CONSOLE BOX INSERT
7. REMOVE LOWER INSTRUMENT COVER LH
8. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
(a) Remove the 3 bolts. |
|
(b) Detach the 8 claws and remove the instrument panel airbag.
(c) Disconnect the connector.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.
Removal
REMOVAL
PROCEDURE
1. PRECAUTION
CAUTION:
Be sure to read Precaution thoroughly before servicing (See page
).
NOTICE:
When removing the front seat assembly RH, perform zero point calibration
and the sensitivity check (See page ).
Whe ...
Body
General Maintenance
GENERAL MAINTENANCE
PROCEDURE
1. TIGHTEN BOLTS AND NUTS ON CHASSIS AND BODY
(a) Where necessary, tighten all the parts of the chassis.
Front axle and suspension
Drivetrain
Rear axle and suspension
Brake system
...