Toyota 4Runner: Removal

Toyota 4Runner Service Manual / Vehicle Interior / Supplemental Restraint Systems / Occupant Classification Ecu / Removal

REMOVAL

PROCEDURE

1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing (See page ).

NOTICE:

When removing the front seat assembly RH, perform zero point calibration and the sensitivity check (See page ).
When replacing the occupant classification ECU, perform zero point calibration and the sensitivity check (See page ).

2. REMOVE FRONT SEAT ASSEMBLY RH

HINT:

Refer to the procedures up to Remove Front Seat Assembly (See page ).

3. REMOVE OCCUPANT CLASSIFICATION ECU

(a) Disconnect the 2 connectors.

(b) Using a screwdriver, detach the claw and remove the occupant classification ECU.

HINT:

Tape the screwdriver tip before use.

Text in Illustration

*1	Protective Tape

Installation

INSTALLATION PROCEDURE 1. INSTALL OCCUPANT CLASSIFICATION ECU (a) Attach the claw to install the occupant classification ECU. NOTICE: If the occupant classification ECU has been dr ...

Occupant Classification System

...

Other materials about Toyota 4Runner:

Reservoir Level Switch Disconnected (C1453,C1454)
DESCRIPTION The brake fluid level warning switch sends the appropriate signal to the skid control ECU when the brake fluid level drops. DTC Code DTC Detection Condition Trouble Area C1453 With th ...

Precaution
PRECAUTION 1. IGNITION SWITCH EXPRESSION HINT: The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section. Expression Ign ...