REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
2. REMOVE LOWER NO. 3 STEERING WHEEL COVER
(a) Detach the 2 claws and remove the cover. |
|
3. REMOVE LOWER NO. 2 STEERING WHEEL COVER
(a) Detach the 2 claws and remove the cover. Text in Illustration
|
|
4. REMOVE STEERING PAD
(a) Using a T30 "TORX" socket wrench, loosen the 2 screws until the groove along the screw circumference catches on the screw case. Text in Illustration
|
|
(b) Pull out the steering pad from the steering wheel as shown in the illustration. Then support the steering pad with one hand. NOTICE: When removing the steering pad, do not pull the airbag wire harness. |
|
(c) Disconnect the horn connector.
(d) Disconnect the 2 connectors and remove the steering pad.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.
Engine Immobiliser System Malfunction (B2799)
DESCRIPTION
This DTC is stored when one of the following occurs: 1) the ECM detects errors
in its own communications with the ID code box; 2) the ECM detects errors in the
communication lines; or 3) the ECU communication ID between the ID code box and
E ...
Rear Door Courtesy Switch
Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
...