REMOVAL
PROCEDURE
1. REMOVE JACK BOX HOLE COVER
2. REMOVE REAR QUARTER PANEL MUDGUARD LH
3. REMOVE REAR QUARTER PANEL MUDGUARD RH
HINT:
Use the same procedure as for the LH side.
4. REMOVE REAR BUMPER COVER
5. REMOVE NO. 3 FLOOR WIRE
6. REMOVE NO. 1 ULTRASONIC SENSOR
(a) Detach the 2 claws to remove the No. 1 ultrasonic sensor from the ultrasonic sensor retainer. HINT: Use the same procedure as for the other side. |
|
7. REMOVE ULTRASONIC SENSOR CLIP
(a) Using a screwdriver, detach the claw to remove the ultrasonic sensor clip from the No. 1 ultrasonic sensor as shown in the illustration. Text in Illustration
HINT:
|
|
8. REMOVE NO. 2 ULTRASONIC SENSOR RETAINER
(a) Detach the 3 claws to remove the No. 2 ultrasonic sensor retainer from the rear bumper cover. HINT: Use the same procedure as for the other side. |
|
9. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER
(a) Detach the 4 claws to remove the No. 1 ultrasonic sensor retainer from the rear bumper cover. HINT: Use the same procedure as for the other side. |
|
Skid Control ECU Communication Stop Mode
DESCRIPTION
Detection Item
Symptom
Trouble Area
Brake Actuator (Skid Control ECU) Communication Stop Mode
Either condition is met:
"Skid Control (ABS/VSC/TRAC)" is not displa ...
System Description
SYSTEM DESCRIPTION
1. GENERAL
This system has the following functions: manual slide open and close, auto slide
open and close, manual tilt up and down, auto tilt up and down, jam protection,
key off operation, key-linked operation and wireless transmitte ...