REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
2. REMOVE BRAKE ACTUATOR ASSEMBLY
(a) Release the lock lever and disconnect the brake actuator connector. NOTICE: Be careful not to allow brake fluid to enter the removed connector. |
|
(b) Using a union nut wrench, disconnect the 6 brake lines from the brake actuator.
(c) Place tags or marks to identify the installation locations of each brake line. HINT:
|
|
(d) Remove the nut, and disconnect the wire harness bracket from the brake actuator bracket. |
|
(e) Remove the 3 nuts and brake actuator with bracket from the body. NOTICE:
|
|
3. REMOVE BRAKE ACTUATOR BRACKET
(a) Remove the 3 bolts and brake actuator bracket from the brake actuator. NOTICE:
|
|
4. REMOVE BRAKE ACTUATOR CASE COLLAR
(a) Remove the 3 brake actuator case collars from the brake actuator bolt cushions. |
|
5. REMOVE BRAKE ACTUATOR BOLT CUSHION
(a) Remove the 3 brake actuator bolt cushions from the brake actuator bracket.
Noise Occurs
PROCEDURE
1.
NOISE CONDITION
(a) Check from which direction the noise comes (front left or right, or rear
left or right).
OK:
The location of the noise source can be determined.
NG
GO TO STEP 3
...
Headlight Relay Circuit
DESCRIPTION
The main body ECU receives headlight dimmer switch information signals, and illuminates
the low beam headlight.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses and bulbs for circuits related to this system before performin ...