Toyota 4Runner: Removal

Toyota 4Runner Service Manual / Brake / Brake System (other) / Brake Pedal(for Hydraulic Brake Booster) / Removal

REMOVAL

PROCEDURE

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

2. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

(a) Remove the lower No. 1 instrument panel airbag assembly (See page ).

3. REMOVE BRAKE PEDAL RETURN SPRING

4. REMOVE PUSH ROD PIN

(a) Remove the clip and push rod pin from the brake pedal lever.

5. REMOVE STOP LIGHT SWITCH ASSEMBLY

(a) Disconnect the stop light switch connector.

(b) Remove the stop light switch (See page ).

6. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY

(a) Remove the brake pedal support reinforcement set bolt.

(b) Remove the hydraulic brake booster assembly (See page ).

Disassembly

DISASSEMBLY PROCEDURE 1. REMOVE BRAKE PEDAL PAD (a) Remove the brake pedal pad from the brake pedal sub-assembly. 2. REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER (a) Remove the stop light switch mo ...

Adjustment

ADJUSTMENT PROCEDURE 1. CHECK BRAKE PEDAL HEIGHT (a) Check the brake pedal height. Pedal height from Floor panel: 158.8 to 168.8 mm (6.25 to 6.46 in.) Text in Illustration ...

Other materials about Toyota 4Runner:

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE RADIATOR GRILLE 2. REMOVE NO. 2 ENGINE ROOM WIRE (a) Disconnect each connector. (b) Detach the 9 clamps to remove the No. 2 engine room wire. 3. REMOVE NO. 1 ULTRASONIC SENSOR 4. REMOVE ULTRASONIC SENSOR CLIP ...

Removal
REMOVAL CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. HINT: The procedure listed below is for the RH side. PROCEDURE 1. PRECAUTION CAUTION: Be sure to read Precaution thoroughly before ...