Toyota 4Runner: Removal

Toyota 4Runner Service Manual / Brake / Brake System (other) / Brake Pedal(for Vacuum Brake Booster) / Removal

REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

2. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

(a) Remove the lower No. 1 instrument panel airbag assembly (See page ).

3. REMOVE BRAKE PEDAL RETURN SPRING

4. REMOVE PUSH ROD PIN

(a) Remove the clip and push rod pin from the brake pedal.

5. REMOVE STOP LIGHT SWITCH ASSEMBLY

(a) Disconnect the stop light switch connector.

(b) Remove the stop light switch assembly (See page ).

6. DISCONNECT BRAKE PEDAL LOAD SENSING SWITCH

(a) Disconnect the brake pedal load sensing switch connector.

7. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY

(a) Remove the brake pedal support reinforcement set bolt.

(b) Remove the brake master cylinder sub-assembly (See page ).

(d) Remove the 4 nuts and brake pedal support assembly.

On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT BRAKE PEDAL LOAD SENSING SWITCH HINT: Do not remove the brake pedal load sensing switch from the brake pedal lever sub-assembly. When the ...

Disassembly

DISASSEMBLY PROCEDURE 1. REMOVE BRAKE PEDAL PAD (a) Remove the brake pedal pad from the brake pedal sub-assembly. 2. REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER (a) Remove the stop light switch mo ...

Other materials about Toyota 4Runner:

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE RADIATOR GRILLE 2. REMOVE NO. 2 ENGINE ROOM WIRE (a) Disconnect each connector. (b) Detach the 9 clamps to remove the No. 2 engine room wire. 3. REMOVE NO. 1 ULTRASONIC SENSOR 4. REMOVE ULTRASONIC SENSOR CLIP ...

Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 2 TELEPHONE BRACKET (a) Install the bracket with the 2 bolts. 2. INSTALL NO. 1 TELEPHONE BRACKET (a) Install the bracket with the 3 bolts. (b) Connect the 2 connectors. 3. INSTALL MAYDAY BATTERY WITH BRACKET (a) At ...