REPLACEMENT
CAUTION / NOTICE / HINT
NOTICE:
PROCEDURE
1. REPLACE BRAKE FLUID
(a) Turn the engine switch on (IG).
(b) Remove the brake master cylinder reservoir filler cap assembly.
(c) Add brake fluid until the fluid level is between the MIN and MAX lines of the reservoir.
(d) While depressing the brake pedal, loosen the bleeder plug of the front disc brake cylinder RH, and then repeatedly depress the brake pedal.
(e) Repeatedly depress the brake pedal until the air is completely bled, and then tighten the bleeder plug while depressing the brake pedal.
Torque:
11 N·m {110 kgf·cm, 8 ft·lbf}
(f) Bleed the air from the bleeder plug of the front disc brake cylinder LH using the same procedure as for the RH side.
(g) With the brake pedal depressed, loosen the bleeder plug of the rear disc brake cylinder RH, continue to hold the brake pedal and allow brake fluid to be drained from the bleeder plug while the pump motor operates.
HINT:
(h) Tighten the bleeder plug, and then release the brake pedal.
Torque:
11 N·m {110 kgf·cm, 8 ft·lbf}
(i) Bleed the air from the bleeder plug of the rear disc brake cylinder LH using the same procedure as for the RH side.
(j) Turn the engine switch off (IG).
(k) Inspect for brake fluid leaks.
(l) Check and adjust the brake fluid level (See page ).
(m) Clear the DTCs (See page ).
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
...
Room Oscillator does not Recognize Key
DESCRIPTION
If the room oscillator does not recognize the key, one of the following may be
the cause: 1) communication between the indoor No. 1 electrical key antenna (front
floor) and electrical key transmitter cannot be performed; 2) communication betwe ...