REPLACEMENT
CAUTION / NOTICE / HINT
NOTICE:
PROCEDURE
1. REPLACEMENT BRAKE FLUID
(a) Remove the master cylinder reservoir filler cap assembly.
(b) Add brake fluid until the fluid level is between the MIN and MAX lines of the reservoir.
(c) Loosen the bleeder plug of the front disc brake cylinder RH.
(d) Repeatedly depress the brake pedal and bleed the air from the bleeder plug of the front disc brake cylinder RH.
NOTICE:
Add fluid as necessary so that the fluid in the reservoir does not decrease below the MIN level.
(e) After air is completely bled out, tighten the bleeder plug while depressing the brake pedal.
Torque:
11 N·m {110 kgf·cm, 8 ft·lbf}
(f) Bleed the air from the bleeder plug of the front disc brake cylinder LH using the same procedure as for the RH side.
(g) Loosen the bleeder plug of the rear disc brake cylinder RH.
(h) Repeatedly depress the brake pedal and bleed the air from the bleeder plug of the rear disc brake cylinder RH.
NOTICE:
Add fluid as necessary so that the fluid in the reservoir does not decrease below the MIN level.
(i) After air is completely bled out, tighten the bleeder plug while depressing the brake pedal.
Torque:
11 N·m {110 kgf·cm, 8 ft·lbf}
(j) Bleed the air from the bleeder plug of the rear disc brake cylinder LH using the same procedure as for the RH side.
(k) Inspect for brake fluid leaks.
(l) Inspect brake fluid level in reservoir (See page ).
(m) Check and clear the DTCs (See page for VSC).
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use these procedures to troubleshoot the lighting system.
*: Use the Techstream.
PROCEDURE
1.
VEHICLE BROUGHT TO WORKSHOP
NEXT
...
ACC Monitor Malfunction (B2274)
DESCRIPTION
This DTC is stored when there is a problem in the ACC output circuit, which is
from the ACC output terminal of the power management control ECU to the ACC relay.
HINT:
When the power management control ECU is replaced with a new one and the ca ...