Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. REMOVE SIDE STEP ASSEMBLY LH (w/ Side Step)
(See page )
2. REMOVE ROCKER PANEL MOULDING LH
(a) Remove the 7 retainers, clip and screw.
(b) Put protective tape around the rocker panel moulding LH.
(c) Remove the 2 screws.
(d) Detach the 7 clips to remove the rocker panel moulding LH.
Text in Illustration
*1 |
Protective Tape |
- |
- |
3. REMOVE NO. 2 ROCKER PANEL MOULDING PROTECTOR (w/o Side Step)
(a) Remove the 2 screws and No. 2 rocker panel moulding protector.
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. INSTALL NO. 2 ROCKER PANEL MOULDING PROTECTOR (w/o Side Step)
(a) Install the No. 2 rocker panel moulding protector with the 2 screws.
2. INSTALL ROCKER PANEL MOULDING LH
(a) Attach the 7 clips to install the rocker panel moulding LH.
(b) Install the 3 screws.
(c) Attach the 7 retainers and clip.
3. INSTALL SIDE STEP ASSEMBLY LH (w/ Side Step)
(See page )
Wheels
If a wheel is bent, cracked or heavily corroded, it should be replaced.
Otherwise, the tire may separate from the wheel or cause a loss of handling
control.
Wheel selection
When replacing wheels, care should be taken to ensure that they are
equivalent ...
Stop Light Switch
Components
COMPONENTS
ILLUSTRATION
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT STOP LIGHT SWITCH ASSEMBLY
(a) Disconnect the connector from the stop light switch assembly.
...