Toyota 4Runner manuals

Toyota 4Runner: Rocker Panel Moulding(w/ Intuitive Parking Assist System)

Toyota 4Runner Service Manual / Vehicle Exterior / Exterior Panels / Trim / Rocker Panel Moulding(w/ Intuitive Parking Assist System)

Components

COMPONENTS

ILLUSTRATION


Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for both the RH and LH sides.
  • The procedure listed below is for the LH side.

PROCEDURE

1. INSTALL NO. 6 ROCKER PANEL REINFORCEMENT

(a) Install the No. 6 rocker panel reinforcement with the 6 bolts.

Torque:

20 N·m {204 kgf·cm, 15 ft·lbf}

2. INSTALL ROCKER PANEL MOULDING LH

(a) Attach the 15 clips to install the rocker panel moulding LH.

(b) Install the 4 screws.

3. INSTALL FRONT FENDER MUDGUARD LH


Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for both the RH and LH sides.
  • The procedure listed below is for the LH side.

PROCEDURE

1. REMOVE FRONT FENDER MUDGUARD LH


2. REMOVE ROCKER PANEL MOULDING LH

(a) Put protective tape around the rocker panel moulding LH.

(b) Remove the 4 screws.

(c) Detach the 15 clips to remove the rocker panel moulding LH.

Text in Illustration

*1

Protective Tape

-

-

3. REMOVE NO. 6 ROCKER PANEL REINFORCEMENT

(a) Remove the 6 bolts and No. 6 rocker panel reinforcement.


Rocker Panel Moulding
Components COMPONENTS ILLUSTRATION Removal REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for both the RH and LH sides. The procedure listed below is for the LH ...

Roof Drip Side Finish Moulding
...

Other materials about Toyota 4Runner:

No Sound can be Heard from Speakers
PROCEDURE 1. CHECK AUDIO SETTINGS (a) In sound output setting mode, set volume, fader and balance to the initial values and check that the sound is normal. OK: Audio system returns to normal. HINT: Sound quality adjustm ...

Tachometer Malfunction
DESCRIPTION In this circuit, the meter CPU receives engine speed signals from the ECM using the CAN communication system. The meter CPU displays the engine speed, which is calculated based on the data received from the ECM. WIRING DIAGRAM PROCEDURE ...

© 2016-2024 | www.to4runner.net

0.0088