Toyota 4Runner manuals

Toyota 4Runner: Room Light(for Rear)

Components

COMPONENTS

ILLUSTRATION


Installation

INSTALLATION

PROCEDURE

1. INSTALL NO. 1 ROOM LIGHT ASSEMBLY

(a) Align the switch parts as shown in the illustration and attach the 4 claws to install the room light switch base to the No. 1 room light assembly.

Text in Illustration

*1

Switch Part of Room Light Switch Base

*2

Switch Part of No. 1 Room Light Assembly


(b) Attach the 4 claws to install the No. 1 room light assembly.


(c) Attach the 2 claws and 2 guides to install the 2 No. 1 room light covers.


(d) Attach the 4 claws to install the No. 1 room light lens.


Removal

REMOVAL

PROCEDURE

1. REMOVE NO. 1 ROOM LIGHT ASSEMBLY

(a) Using a screwdriver, detach the 4 claws and remove the No. 1 room light lens.

HINT:

Tape the screwdriver tip before use.

Text in Illustration

*1

Protective Tape


(b) Using a screwdriver, detach the 2 claws and 2 guides and remove the 2 No. 1 room light covers.

HINT:

Tape the screwdriver tip before use.

Text in Illustration

*1

Protective Tape


(c) Using a screwdriver, detach the 4 claws and disconnect the No. 1 room light assembly as shown in the illustration.

HINT:

Tape the screwdriver tip before use.

Text in Illustration

*1

Protective Tape


(d) Using a screwdriver, detach the 4 claws and disconnect the room light switch base from the No. 1 room light assembly.


Room Light(for Front)
Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT MAP LIGHT ASSEMBLY (a) Measure the resistance according to the value(s) in the table below. Sta ...

Meter / Gauge / Display
...

Other materials about Toyota 4Runner:

Inspection
INSPECTION PROCEDURE 1. INSPECT MAGNET CLUTCH ASSEMBLY (a) Check the magnet clutch operation. (1) Confirm that the magnet clutch hub and magnet clutch rotor lock when the positive (+) lead of the battery is connected to terminal 3 of the magnet clutch, ...

Communication Malfunction No. 1 (B2797)
DESCRIPTION This DTC is stored when a communication error occurs between the transponder key amplifier and transponder key ECU assembly. Some possible reasons for the communication error are: 1) 2 or more ignition keys are positioned too close together, o ...

© 2016-2024 | www.to4runner.net

0.0084