Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
2. REMOVE ROOF HEADLINING ASSEMBLY
(See page )
3. REMOVE SATELLITE RADIO ANTENNA ASSEMBLY
(a) Disconnect the connector. |
|
(b) Remove the bolt, washer and holder and satellite radio antenna assembly.
(c) Disengage the 3 claws and 3 guides to remove the satellite radio antenna assembly from outer antenna cover. |
|
(d) When reusing the roof antenna assembly: (1) Remove the seal. |
|
Installation
INSTALLATION
PROCEDURE
1. INSTALL SATELLITE RADIO ANTENNA ASSEMBLY
(a) When reusing the roof antenna assembly:
(1) Install a new seal.
(b) Engage the 3 guides and 3 claws to install the satellite radio antenna assembly to outer antenna cover.
(c) Temporarily install the satellite radio antenna assembly on the vehicle.
(d) Install a new washer and holder with the bolt.
Torque:
9.5 N·m {97 kgf·cm, 84 in·lbf}
(e) Connect the connector.
2. INSTALL ROOF HEADLINING ASSEMBLY
(See page )
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
4. CHECK SRS WARNING LIGHT
(See page )
System Diagram
SYSTEM DIAGRAM
Communication Table
Sender
Receiver
Signal
Line
ECM
Main Body ECU (Multiplex Network Body ECU)
Shift position P signal
Transmission informatio ...
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
HINT:
If a trouble code is output during the DTC check, inspect the trouble areas listed
for that code. For details of the code, refer to the "See page" below.
Power Window Control System
DTC Code
...