Toyota 4Runner: Satellite Radio Broadcast cannot be Selected or After Selecting Broadcast, Broadcast cannot be Added into Memory

Toyota 4Runner Service Manual / Audio / Visual / Telematics / Navigation / Multi Info Display / Navigation System / Satellite Radio Broadcast cannot be Selected or After Selecting Broadcast, Broadcast cannot be Added into Memory

CAUTION / NOTICE / HINT

NOTICE:

Some satellite radio broadcasts require payment. A contract must be made between a satellite radio company and the user. If the contract expires, it will not be possible to listen to the broadcast.

PROCEDURE

1.	CHECK SATELLITE RADIO

(a) Check radio condition.

Result	Proceed to
Broadcast cannot be selected	A
Broadcast can be selected, but selection can not be memorized	B

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

2.	CHECK SATELLITE RADIO

(a) Check the number of preset channels.

OK:

36 channels have already been preset.

END (ONLY 36 CHANNELS CAN BE PRESET)

3.	CHECK BATTERY

(a) Check if the battery was replaced.

OK:

Battery was not replaced.

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

4.	ADD PRESET CHANNEL INTO MEMORY AGAIN

(a) Check if the preset channels that have been cleared can be added into memory again.

OK:

Preset channels can be added into memory.

END

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Satellite Radio Broadcast cannot be Received

CAUTION / NOTICE / HINT NOTICE: Some satellite radio broadcasts require payment. A contract must be made between a satellite radio company and the user. If the contract expires, it w ...

Traffic Information is not Displayed

CAUTION / NOTICE / HINT NOTICE: Traffic information requires payment. An "XM Nav Traffic" contract must be made between the satellite radio company and the user. If the contrac ...

Other materials about Toyota 4Runner:

Short to GND in Hall Effect Sensor Power Circuit (31)
DESCRIPTION When there is a short to GND in the side auto step motor hall sensor power circuit, the side auto step controller ECU assembly does not operate the automatic running board. DTC No. Detection Condition Trouble ...

Lost Communication with ECM / PCM "A" (U0100)
DESCRIPTION DTC Code DTC Detection Condition Trouble Area U0100 There is no communication from the ECM. Power source or inside ECM ECM main wire or connector ECM ...