Toyota 4Runner: Scanning radio stations (excluding XM® Satellite Radio)
Scanning the preset radio stations
Press and hold
until you hear a beep.
Preset stations will be played for 5 seconds each.
When the desired station is
reached, press 
again.
Scanning all radio stations within range
Press
.
All the stations with reception will be played for 5 seconds each.
When the desired station is
reached, press again.
Displaying radio text messages (for type B and C, FM mode only)
When a new radio text message is received, “MSG” is shown on the display. To
display the message, press 
.
If the text continues past the end of the display, “
” is displayed. Press and hold 
until you hear a beep.
Text messages are not displayed while driving.
Setting station presets (excluding XM® Satellite Radio)
Search for desired stations by
turning
or
or pressing “∧” or “∨” on
.
Press and hold a button (from
to
) until you hear a beep.
Type B and C: Each time is
pressed, station ...
XM® Satellite Radio (if equipped)
Receiving XM® Satellite Radio
Press
or
.
The display changes as follows each time
or
is pressed.
Type A: AM → SAT1 → SAT2 → SAT3 Type B and C: AM → FM → SAT
Turn
or
to selec ...
Other materials about Toyota 4Runner:
Disassembly
DISASSEMBLY
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for both the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the c ...
Open in Stop Light Switch Circuit (C1425)
DESCRIPTION
The skid control ECU receives the stop light switch assembly signal and detects
the brake pedal operation status.
The skid control ECU has an open detection circuit, which stores this DTC if
it detects an open in the stop light input line of ...
0.0151