Toyota 4Runner manuals

Toyota 4Runner: Shifting between H4 and L4

Shifting from H4 to L4

Stop the vehicle completely and
continue to depress the brake pedal.

Shift the shift lever to N.


Type A

Shift the front-wheel drive
control lever to L4.

Type B

Push the “UNLOCK” button and
then push and turn the frontwheel drive control switch to L4.

The low speed four-wheel drive indicator will turn on.

Shifting from L4 to H4

Stop the vehicle completely and
continue to depress the brake pedal.

Shift the shift lever to N.


Type A

Shift the front-wheel drive
control lever to H4.

Type B

Push the “UNLOCK” button and
turn the front-wheel drive control switch to H4.

The low speed four-wheel drive indicator will go off.

When the front-wheel drive control lever or switch is shifted to L4

VSC and TRAC are automatically turned off.

If the four-wheel drive indicator flashes

The transfer mode may not successfully change. Drive straight ahead while accelerating or decelerating, or drive in reverse.

If the low speed four-wheel drive indicator continues to flash

The transfer mode may not successfully change. Operate the four-wheel drive control switch again.

If the low speed four-wheel drive indicator continues to flash and a buzzer sounds

The shift lever is not in N and/or the vehicle is moving. Stop the vehicle completely, shift the shift lever to N and make sure that the indicator stops flashing.

If the four-wheel drive or low speed four-wheel drive indicator flashes rapidly

There may be a malfunction in the four-wheel drive system. Have the vehicle inspected by your Toyota dealer immediately.

Four-wheel drive usage frequency

You should drive in four-wheel drive for at least 10 miles (16 km) each month.

This will assure that the front drive components are lubricated.

CAUTION

Shifting the front-wheel drive control lever or switch from H2 to H4 while driving

Never operate the front-wheel drive control lever or switch if the wheels are slipping.

Stop the slipping or spinning before shifting.

Shifting between H2 and H4
Shifting from H2 to H4 Type A Reduce vehicle speed to less than 50 mph (80 km/h). Shift the front-wheel drive control lever to H4. Type B Reduce vehicle speed to less than 62 mph (100 km/ ...

Four-wheel drive system (full-time 4WD models)
Use the four-wheel drive control switch to select the following transfer modes: 1. H4F (high speed position) Use this for normal driving on dry hard-surfaced roads. This position gives greate ...

Other materials about Toyota 4Runner:

Installation
INSTALLATION CAUTION / NOTICE / HINT PROCEDURE 1. INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY (a) Install a new O-ring to the brake master cylinder sub-assembly. (b) Install the brake master cylinder sub-assembly with 2 nuts. Torque: 13 N·m {127 kgf·c ...

Diagnosis System
DIAGNOSIS SYSTEM 1. BUS CHECK (a) Select "CAN Bus Check" from "System Select". 2. CHECK FOR INSTALLED SYSTEMS (ECUS AND SENSORS) THAT USE CAN COMMUNICATION (a) The systems (ECUs and sensors) that use CAN communication vary depending o ...

© 2016-2024 | www.to4runner.net

0.0095