DESCRIPTION
When there is a short in the side auto step motor circuit, the side auto step controller ECU assembly halts the operation of the automatic running board.
DTC No. |
Detection Condition |
Trouble Area |
---|---|---|
11 |
More than 44 A of current is flowing through the side auto step motor LH. |
|
12 |
More than 44 A of current is flowing through the side auto step motor RH. |
WIRING DIAGRAM
PROCEDURE
1. |
CHECK HARNESS AND CONNECTOR (SIDE AUTO STEP MOTOR - SIDE AUTO STEP CONTROLLER ECU) |
(a) Disconnect the O25*1 or N23*2 side auto step motor assembly connector.
(b) Disconnect the A42 side auto step controller ECU assembly connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
for LH
Tester Connection |
Condition |
Specified Condition |
---|---|---|
A42-3 (STW1) - A42-4 (DPL1) |
Always |
10 kΩ or higher |
for RH
Tester Connection |
Condition |
Specified Condition |
---|---|---|
A42-2 (STW2) - A42-1 (DPL2) |
Always |
10 kΩ or higher |
OK |
REPLACE SIDE AUTO STEP MOTOR ASSEMBLY |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE HOOD TO RADIATOR SUPPORT SEAL
(a) Using a clip remover, remove the 7 clips and hood to radiator support
seal.
NOTICE:
If the clips are damaged or fall off, replace them with new clips.
...
Operating an iPod
Connecting an iPod enables you to enjoy music from the vehicle speakers.
Connecting an iPod
Pull up the lid.
Open the cover and connect an iPod using an iPod cable.
Turn on the power of the iPod if it is not turned on.
Press
.
Control panel
...