DESCRIPTION
When there is a short to battery in the side auto step motor hall sensor power circuit, the side auto step controller ECU assembly will not operate the automatic running board.
DTC No. |
Detection Condition |
Trouble Area |
---|---|---|
32 |
The side auto step motor hall sensor voltage is more than 4 V when the automatic running board is not in operation. |
|
WIRING DIAGRAM
PROCEDURE
1. |
CHECK HARNESS AND CONNECTOR (SIDE AUTO STEP MOTOR POWER SOURCE) |
(a) Disconnect the O25*1 and N23*2 side auto step motor assembly connector.
(b) Measure the voltage according to the value(s) in the table below. Standard Voltage: for LH
for RH
|
|
OK |
REPLACE SIDE AUTO STEP MOTOR ASSEMBLY |
|
2. |
CHECK HARNESS AND CONNECTOR (SIDE AUTO STEP MOTOR - SIDE AUTO STEP CONTROLLER ECU) |
(a) Disconnect the A41 side auto step controller ECU assembly connector.
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
A41-14 (SSR+) - Body Ground |
Always |
Below 4 V |
OK |
REPLACE SIDE AUTO STEP CONTROLLER ECU ASSEMBLY |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for both the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL QUARTER WINDOW GLASS SPACER LH
(a) Apply Primer G to the rear ...
Manual (SOS) Switch Green Indicator Malfunction (B1571)
DESCRIPTION
This DTC is stored when the DCM (Telematics Transceiver) detects an open or short
in the manual (SOS) switch green indicator circuit of the manual (SOS) switch. The
manual (SOS) switch green indicator illuminates after the ignition switch is t ...