Toyota 4Runner: Short to Battery in Motor RH Circuit (25,26)
DESCRIPTION
When there is a short to battery in the side auto step motor circuit, the side auto step controller ECU assembly will not operate the automatic running board.
|
DTC No. |
Detection Condition |
Trouble Area |
|---|---|---|
|
25 |
Short to battery in the stowing or deploying side of the side auto step motor LH circuit when the automatic running board is not in operation. |
|
|
26 |
Short to battery in the stowing or deploying side of the side auto step motor RH circuit when the automatic running board is not in operation. |
WIRING DIAGRAM
.png)
PROCEDURE
|
1. |
CHECK HARNESS AND CONNECTOR (SIDE AUTO STEP MOTOR - SIDE AUTO STEP CONTROLLER ECU) |
(a) Disconnect the O25*1 or N23*2 side auto step motor assembly connector.
- *1: for LH
- *2: for RH
(b) Disconnect the A42 side auto step controller ECU assembly connector.
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
for LH
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
A42-3 (STW1) - Body ground |
When the automatic running board LH is not in operation. |
Below 1 V |
|
A42-4 (DPL1) - Body ground |
When the automatic running board LH is not in operation. |
Below 1 V |
for RH
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
A42-2 (STW2) - Body ground |
When the automatic running board RH is not in operation. |
Below 1 V |
|
A42-1 (DPL2) - Body ground |
When the automatic running board RH is not in operation. |
Below 1 V |
| OK | .gif) |
REPLACE SIDE AUTO STEP CONTROLLER ECU ASSEMBLY |
| NG | |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
Short to Battery in Hall Effect Sensor Power Circuit (32)
DESCRIPTION
When there is a short to battery in the side auto step motor hall sensor power
circuit, the side auto step controller ECU assembly will not operate the automatic
running board.
...
Short to GND in Hall Effect Sensor Power Circuit (31)
DESCRIPTION
When there is a short to GND in the side auto step motor hall sensor power circuit,
the side auto step controller ECU assembly does not operate the automatic running
board.
...
Other materials about Toyota 4Runner:
Invalid Data Received from Deceleration Sensor (C1442,C1443)
DESCRIPTION
The skid control ECU receives signals from the yaw rate and acceleration sensor
via the CAN communication system.
DTC Code
DTC Detection Condition
Trouble Area
C1442
An invalid data s ...
Removal
REMOVAL
PROCEDURE
1. REMOVE SPIRAL CABLE SUB-ASSEMBLY
(a) Remove the spiral cable sub-assembly (See page
).
2. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY
3. REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY
(a) Disconnect the connector.
...
0.0072