Toyota 4Runner manuals

Toyota 4Runner: Short to GND in Hall Effect Sensor Power Circuit (31)

Toyota 4Runner Service Manual / Vehicle Exterior / Exterior Panels / Trim / Automatic Running Board System / Short to GND in Hall Effect Sensor Power Circuit (31)

DESCRIPTION

When there is a short to GND in the side auto step motor hall sensor power circuit, the side auto step controller ECU assembly does not operate the automatic running board.

DTC No.

Detection Condition

Trouble Area

31

The side auto step motor hall sensor voltage is less than 4 V when the automatic running board is in operation.

  • Wire harness or connector
  • Side auto step motor assembly
  • Side auto step controller ECU assembly

WIRING DIAGRAM


PROCEDURE

1.

CHECK HARNESS AND CONNECTOR (SIDE AUTO STEP MOTOR POWER SOURCE)

(a) Disconnect the O25*1 and N23*2 side auto step motor assembly connector.

  • *1: for LH
  • *2: for RH

(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

for LH

Tester Connection

Condition

Specified Condition

O25-3 (+1) - Body Ground

When the automatic running board LH is being deployed or stowed.

8 to 11 V

for RH

Tester Connection

Condition

Specified Condition

N23-3 (+2) - Body Ground

When the automatic running board RH is being deployed or stowed.

8 to 11 V

Text in Illustration

*A

for LH

*B

for RH

*a

Front view of wire harness connector

(to Side Auto Step Motor Assembly)



OK

REPLACE SIDE AUTO STEP MOTOR ASSEMBLY


NG

2.

CHECK HARNESS AND CONNECTOR (SIDE AUTO STEP MOTOR - SIDE AUTO STEP CONTROLLER ECU)

(a) Disconnect the A41 side auto step controller ECU assembly connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

A41-14 (SSR+) - Body Ground

Always

10 kΩ or higher

A41-14 (SSR+) - A41-5 (SSR-)

Always

10 kΩ or higher


OK

REPLACE SIDE AUTO STEP CONTROLLER ECU ASSEMBLY


NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

Short to Battery in Motor RH Circuit (25,26)
DESCRIPTION When there is a short to battery in the side auto step motor circuit, the side auto step controller ECU assembly will not operate the automatic running board. DTC No. ...

Open in Motor LH Circuit (22,24)
DESCRIPTION When there is an open in the side auto step motor circuit, the side auto step controller ECU assembly does not operate the automatic running board. DTC No. Detect ...

Other materials about Toyota 4Runner:

All Door Entry Lock/Unlock Functions and Wireless Functions do not Operate
DESCRIPTION When the entry operation and wireless operation of the door lock functions do not operate, a malfunction or wave interference may be occurring in either of the following: 1) the signal communication line between the door control receiver and ...

Installation
INSTALLATION PROCEDURE 1. INSTALL WIRELESS DOOR LOCK BUZZER (a) Connect the connector. (b) Attach the clamp to install the wireless door lock buzzer. 2. INSTALL FRONT FENDER LINER LH (w/ Intuitive Parking Assist System) (a) Install the front fender liner ...

© 2016-2024 | www.to4runner.net

0.0263