DESCRIPTION
This DTC is stored when the engine switch power source supply line is open or shorted.
DTC Code |
DTC Detection Condition |
Trouble Area |
---|---|---|
B278A |
The engine switch power source supply line is open or shorted. |
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Before replacing the certification ECU, refer to Registration (See page ).
PROCEDURE
1. |
CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - ENGINE SWITCH) |
(a) Disconnect the F79 ECU connector.
(b) Disconnect the F71 switch connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
F79-28 (VC5) - F71-14 (VC5) |
Always |
Below 1 Ω |
F79-36 (AGND) - F71-8 (AGND) |
||
F79-28 (VC5) or F71-14 (VC5) - Body ground |
Always |
10 kΩ or higher |
F79-36 (AGND) or F71-8 (AGND) - Body ground |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
2. |
CHECK CERTIFICATION ECU |
(a) Using an oscilloscope, check the waveform. Measurement Condition
OK: Waveform is output normally (refer to illustration). Text in Illustration
|
|
OK |
REPLACE ENGINE SWITCH |
NG |
REPLACE CERTIFICATION ECU |
Confirm Vehicle Headunit Functionality
PROCEDURE
1.
CHECK CUSTOMER'S CELLULAR PHONE COMPATIBILITY
(a) Go to TIS "Bluetooth" Compatibility Portal and check if the cellular phone
is compatible.
Result
Proceed to
...
AV Signal Stoppage (Low Battery Voltage) (B158F)
DESCRIPTION
This DTC is stored when a video or audio signal is interrupted due to battery
voltage input to the navigation receiver assembly dropping temporarily.
DTC No.
DTC Detection Condition
Trouble Area
...