Toyota 4Runner manuals

Toyota 4Runner: Side Turn Signal Light Assembly

Toyota 4Runner Service Manual / Vehicle Exterior / Lighting (ext) / Side Turn Signal Light Assembly

Components

COMPONENTS

ILLUSTRATION


Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for both the RH and LH sides.
  • The procedure listed below is for the LH side.

PROCEDURE

1. REMOVE OUTER MIRROR LH


2. REMOVE OUTER MIRROR COVER LH


3. REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY LH

(a) Retract the outer rear view mirror assembly LH.

(b) Remove the 2 screws.


(c) Detach the 4 claws.

(d) Turn the socket in the direction indicated by the arrow to remove the body cover.


(e) Detach the 2 claws.


(f) Disconnect the connector and remove the side turn signal light assembly LH.

Inspection

INSPECTION

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for both the RH and LH sides.
  • The procedure listed below is for the LH side.

PROCEDURE

1. REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY LH

(a) Apply battery voltage to the connector and check the light illumination condition.

OK:

Condition

Specified Condition

Battery positive (+) → Terminal 1(B)

Battery negative (-) → Terminal 2(E)

Illuminates

Text in Illustration

*a

Component without harness connected

(Side Turn Signal Light Assembly LH)

If the result is not as specified, replace the side turn signal light assembly LH.


Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for both the RH and LH sides.
  • The procedure listed below is for the LH side.

PROCEDURE

1. INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY LH

(a) Connect the connector.

(b) Attach the 2 claws to install the side turn signal light assembly LH.

(c) Retract the outer rear view mirror assembly LH.

(d) Turn the socket in the direction indicated by the arrow to install it.


(e) Attach the 4 claws to install the body cover.

(f) Install the 2 screws.

2. INSTALL OUTER MIRROR COVER LH


3. INSTALL OUTER MIRROR LH


Relay
On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. REMOVE HEADLIGHT RELAY (a) Remove the headlight relay from the engine room relay box. ...

Stop Light Switch
Components COMPONENTS ILLUSTRATION On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT STOP LIGHT SWITCH ASSEMBLY (a) Disconnect the connector from the stop light ...

Other materials about Toyota 4Runner:

Precaution
PRECAUTION 1. NOTICE FOR INITIALIZATION NOTICE: When disconnecting the cable from the negative (-) battery terminal, some systems need to be initialized after the cable is reconnected (See page ). 2. PRECAUTIONS FOR PUSH-BUTTON START FUNCTION (a) Befo ...

Open in Motor LH Circuit (22,24)
DESCRIPTION When there is an open in the side auto step motor circuit, the side auto step controller ECU assembly does not operate the automatic running board. DTC No. Detection Condition Trouble Area 22 ...

© 2016-2024 | www.to4runner.net

0.0072