DESCRIPTION
The slip indicator light blinks during VSC, TRAC, crawl control, multi-terrain select control or trailer sway control operation. When the system fails, the slip indicator light comes on to warn the driver.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
When replacing the master cylinder solenoid, perform calibration (See page ).
PROCEDURE
1. |
CHECK FOR DTC |
(a) Check for DTCs (See page ).
Result |
Proceed to |
---|---|
DTC is not output |
A |
DTC is output |
B |
B |
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS |
|
2. |
CHECK CAN COMMUNICATION LINE |
(a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON.
(d) Turn the Techstream on.
(e) Select CAN Bus Check from the System Selection Menu screen and follow the prompts on the screen to inspect the CAN bus (See page ).
OK:
CAN Bus Check indicates no malfunctions in CAN communication.
NG |
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) |
|
3. |
READ VALUE USING TECHSTREAM (SLIP INDICATOR LIGHT) |
(a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON.
(d) Turn the Techstream on.
(e) Enter the following menus: Chassis / ABS/VSC/TRAC / Data List.
ABS/VSC/TRAC
Tester Display |
Measurement Item/Range |
Normal Condition |
Diagnostic Note |
---|---|---|---|
Slip Indicator Light |
Slip indicator light/ ON or OFF |
ON: Indicator light on OFF: Indicator light off |
- |
(f) When performing the Slip Indicator Light Active Test, check Slip Indicator Light in the Data List (See page ).
Tester Display |
Test Part |
Control Range |
Diagnostic Note |
---|---|---|---|
Slip Indicator Light |
Slip Indicator Light |
Indicator light ON/OFF |
Observe the combination meter. |
Result |
Proceed to |
|
---|---|---|
Data List Display |
Data List Display when Performing Active Test ON/OFF Operation |
|
ON |
Does not change between ON and OFF |
A |
Changes between ON and OFF |
B |
|
OFF |
Does not change between ON and OFF |
A |
Changes between ON and OFF |
B |
A |
REPLACE MASTER CYLINDER SOLENOID |
B |
GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) |
Data Signal Circuit between Radio Receiver and Extension Module
DESCRIPTION
The stereo component tuner assembly sends the sound data signal or image data
signal from a device to the radio and display receiver assembly via this circuit.
WIRING DIAGRAM
PROCEDURE
1.
CHECK HARNESS AND CONNECTOR ( ...
Diagnosis System
DIAGNOSIS SYSTEM
1. CHECK WARNING LIGHT
NOTICE:
When there is a problem with the tire pressure warning system, the tire
pressure warning light blinks at 0.5 second intervals and comes on after
1 minute.
When the malfunction has been corr ...